Working Principle and Feature: On the basis of introducing advanced technologies from abroad and making continuous innovations, our company has developed all kinds of high-performance feeders to meet the requirements of conveying various plastic materials. All models, made of stainless steel, equipped with highly-efficient vacuum motor and overload protection device, are of lightweight, long durability, strong suction power, easy to install and operate.
The ZF series feeders are mainly used for mixed materials which are of a bulk specific weight of over 0.5 g/cm3 but less than 3 g/cm3, cohesion-less and in powder form, and are mainly applicable for food, chemicals and plastics industries. This machine uses high-pressure
air for back flushing, which shakes out powder momentarily and maintains a good effect. It is also easy to clean, without any mechanical dead-end, fast to change material, of small space, convenient to move, thus applicable for transportation of all kinds of powder materials.
With Sets Set Preparation
Vacuum Kpa
29Kpa
-0.093Mpa
Pressure Kpa
〈40 Kpa
〈1㎏/㎝2
Power
Three-phase four-wire system380V50Hz
Continuous transmission capacityKg/h
5m
300
300
Conveying pipe diameter (mm)
50
76
Inspiratory diameter(mm)
50
76